Leveling
Differential leveling carries elevations from a benchmark using a level and a rod. The bookkeeping is simple; the discipline is in the checks.
The three readings
- Backsight (BS): rod reading on a point of known elevation. HI = elevation + BS.
- Foresight (FS): rod reading on the next point. Elevation = HI − FS.
- Turning point (TP): a stable point read as a foresight, then (after the level moves) as a backsight, to carry the run forward.
- Intermediate sight / side shot (IS): an extra foresight from the same setup (an invert, a grade shot). It gets an elevation but does not carry the run.
Field-note checks
For the points that carry the run, ΣBS − ΣFS must equal the last elevation minus the first. This proves the arithmetic — not the readings. The real check is to close: end on a second benchmark, or loop back to the first. The difference between the computed and known elevation is the misclosure.
Adjusting a level run
Errors build up with each setup (or each unit of distance). The simplest adjustment gives a point reached on setup k a correction of −e·k/n for n setups. With balanced sight lengths this is the same as distributing by distance.
Accuracy is usually expressed as an allowable misclosure proportional to the square root of the run length. FGCS (1984) vertical-control classes range from 3 mm·√K (first order) to 12 mm·√K (third order), K in kilometres; construction and agency specs often use their own value in feet × √miles.
Main error sources
- Collimation (line of sight not level) and curvature and refraction: cancelled by keeping each backsight and foresight about equal in length.
- Rod not plumb: always reads too high. Use a rod level or rock the rod and take the smallest reading.
- Settlement of the instrument or turning point on soft ground; use solid TPs (a turtle, a spike, a curb top) and work quickly.
- Heat shimmer: keep sights short and off the ground in hot weather.
- Blunders: misreading the foot or tenth, or booking a reading in the wrong column. Read, book, then read again.
Trigonometric leveling
A total station gives elevation differences from slope distance and zenith angle: Δh = S·cos z + instrument height − rod (prism) height. Over long sights add the curvature-and-refraction correction (about 0.0206 ft × (distance in thousands of feet)²).
Try it in the calculators
- Open the calculator: Leveling notesTry an exampleDifferential leveling loop BM1 → BM1 (9 setups)
- Open the calculator: Slope, grade & stationingTry an exampleBack tangent of the Figure 3-21 summit curve: 12+00 @ 124.80 to 14+00 @ 131.20
When not to use: this guide teaches the method. It is not a survey standard and does not replace your state's minimum technical standards for surveys or the project specifications.
Original explanations written for this site. Plane-surveying fundamentals only — not exam questions, and not a substitute for a surveying text or your agency's survey manual.