Traverse basics

A traverse is a chain of measured lines and angles. Checking how well it closes is the first quality test of any survey control.

Closed loop or connecting

A loop traverse starts and ends at the same point. A connecting traverse runs between two points of known position, ideally with a known direction at each end. An open traverse that ends on an unknown point has no check at all and should be avoided for anything that matters.

Step 1 — check and balance the angles

For a loop with n stations the interior angles must total (n − 2)·180°. The difference is the angular misclosure. A small misclosure (a few seconds per angle for a good total station) is usually spread equally over the angles; a large one means a blunder — often an exterior angle recorded as interior, or a misread minute.

Step 2 — carry azimuths around

Start from a known or assumed azimuth on the first line. For a loop run counter-clockwise the interior angles are angles to the right: next Az = previous Az + 180° + angle. Run clockwise, they are angles to the left, and you subtract. Coming back to the first line should reproduce its azimuth exactly if the angles were balanced.

Step 3 — latitudes and departures

Each line becomes a north-south component (latitude, L·cos Az) and an east-west component (departure, L·sin Az). Around a loop both columns should sum to zero; on a connecting traverse they should equal the coordinate difference between the end points.

Step 4 — misclosure and precision

e = √(ΣLat² + ΣDep²)    precision = 1 : (perimeter ÷ e)

Example: a four-sided lot with a 1,715 ft perimeter misses by 0.06 ft. Precision = 1 : 28,600. Whether that is acceptable depends on the job: construction layout and topo control are often specified around 1:10,000 to 1:20,000; boundary and geodetic work has its own standards. Always check the contract or agency specification.

Step 5 — adjust

The compass (Bowditch) rule gives each latitude a correction of −ΣLat × (line length ÷ perimeter), and the same for departures. Long lines take more of the error. It is quick and assumes angles and distances are about equally good. The transit rule (proportional to the size of each latitude/departure) and least squares are alternatives; least squares is the standard for networks.

Finding a blunder

Area from the result

Once coordinates are adjusted, the enclosed area follows from the coordinate (shoelace) method or, equivalently, the double meridian distance method. Both appear in the area tool so you can see they agree.

Try it in the calculators

When not to use: this guide teaches the method. It is not a survey standard and does not replace your state's minimum technical standards for surveys or the project specifications.

Original explanations written for this site. Plane-surveying fundamentals only — not exam questions, and not a substitute for a surveying text or your agency's survey manual.